Back to Blog
Magic mirror raspberry pi7/1/2023 You can Now connect to the Pi with a SSH client. After a short time open your routers DHCP lease table to find the Raspberry Pi’s IP-address. Now insert the SD-card in your Raspberry Pi.Ĭonnect the Raspberry Pi to your mirror-monitor, and your router with an Ethernet cable. Verify that file is created and eject SD-Card. In Windows this is done by running type NUL > G:\ssh in CMD (Replace G with partition letter.). To enable SSH by default make a new, empty file with no extension named ssh in the root of the boot partition. Then click Select drive and then your SD-Card.Īfter flashing, if the boot partition is not showing on your computer, eject and re-insert the card in the computer. Press Select image and select the Raspbian Buster with desktop zip-file. To flash the image to your SD-card, download and install/run EtcherĪfter installation insert the SD-card in your computer and start Etcher. Go to and download the last Raspbian Buster with desktop image zip-file, which is -raspbian-buster.zip at the time of writing this guide. Download, flash and prepare SD-card image It is mostly used to make interfaces for smart mirrors (Monitors behind transparent mirrors), but it is also used to make good looking information displays without mirrors. MagicMirror² is a open source and 100% free modular smart mirror platform that run on a raspberry pi. Module installations and general configuration of MagicMirror² is not a part of this tutorial. The current version of MagicMirror² supports Raspberry Pi 2 and Raspberry Pi 3, so you will need one of these. No connection of keyboard or mouse to the Raspberry Pi required The guide will also show how to install/enable extra tools like SSH, Samba and VNC to make MagicMirror² completely ready for configuration and use. In this guide I will explain in detail how you install MagicMirror² on a Raspberry Pi.
0 Comments
Read More
Leave a Reply. |